To Next Page

To Previous Page

Component Identiﬁcation

Proportioner Control Panel

Figure 6

Advanced Display Module (ADM), page 21

Engine Control Module, page 29

PF* Component A Feed Pump Air Outlet

PG* Component B Feed Pump Air Outlet

PH* Agitator Air Outlet

PJ* Gun Air Outlet

Component A Feed Pump Air Regulator

Component B Feed Pump and Agitator Air

Regulator

PM Gun Air Regulator

PN Component A Feed Pump Pressure Gauge

PP Component B Feed Pump and Agitator

Pressure Gauge

Gun Pressure Gauge

* Not for breathing air use.

332636C 19

Table of Contents2
Warnings3
Important Isocyanate Information8
Models10
Approvals12
Accessories12
Supplied Manuals13
Related Manuals13
Typical Installation, Without Circulation14
Typical Installation, with Circulation15
Component Identiﬁcation16
- Generator18
- Proportioner Control Panel19
- Air Compressor20
- Advanced Display Module21
- Electrical Enclosure26
- Electrical Cabinet27
- Motor Control Module (MCM)28
- Engine Control Module29
- Load Center30
  - Connections31
- Circuit Breakers32
Overview34
Setup37
- Locate Reactor37
- Trailer Setup Guidelines38
- Install Wall (Optional)39
- Connect Battery41
- Add Fuel41
- General Equipment Guidelines42
- Electrical Connections42
- Connect Feed Pumps42
- Breathing Air42
- Connect Pressure Relief Lines43
- Install Fluid Temperature Sensor43
- Connect Heated Hose43
- Close Gun Fluid Manifold Valves a and44
- Connect Whip Hose to Gun or Gun Fluid44
  - Manifold44
- Pressure Check Hose44
- Connect Remote Display Module44
- Grounding45
- Supply Wet Cups with Throat Seal Liquid46
  - (Tsl)46
Operation47
- Initial System Setup47
- Register and Activate the Graco Insite48
- Advanced Setup Screens50
- System 151
- System 251
- Recipes51
- Run Mode53
Startup57
Fluid Circulation61
- Circulation through Reactor61
- Circulation through Gun Manifold62
- Jog Mode62
Spraying63
- Spray Adjustments64
- Manual Hose Heat Mode65
Shutdown67
Pressure Relief Procedure69
Flushing70
System Errors71
- Troubleshoot Errors72
- Clear Alarm72
Maintenance73
- Preventative Maintenance Schedule73
- Wetcup73
- Fluid Inlet Strainer Screen73
- Coolant Filter73
- Grease Circulation Valves73
- ISO Lubrication Level73
- Wiring Connections73
- Dust Protection73
- Coolant Levels73
- Clean Heat Sink Fins74
- Engine Maintenance74
- Air Compressor Oil Level74
- Fuel Tank75
- Flush Inlet Strainer Screen75
- Pump Lubrication System76
USB Data77
- USB Logs77
- System Conﬁguration Settings78
- Download Log Files79
- Custom Language File79
- Upload Procedure80
Appendix A: Engine Control Module81
Dimensions84
Performance Charts87
Technical Speciﬁcations90
Graco Extended Warranty for Integrated93
- Reactor® 2 Components93

Brand	Graco
Model	Reactor 2 Series
Category	Water Pump
Language	English

Graco Reactor 2 Series User Manual

Table of Contents

Questions and Answers:

Graco Reactor 2 Series Specifications

Related product manuals