Graco T2 - User Manual

Questions and Answers

A
Abigail LaraJul 27, 2025
What to do if my Graco Water Pump fails to operate?
- E
  Erin BurgessJul 27, 2025
  If your Graco Water Pump fails to operate, several issues could be the cause. The air motor may be dirty or worn, requiring cleaning or servicing. Check for inadequate air supply or restricted lines; clean the lines or increase the air supply. Also, ensure that the air valves are open and clear. A clogged fluid hose or valve could also be the culprit, so clear any blockages. Finally, inspect the valves and seals for wear or damage and service them if needed.
T
tiffany28Jul 30, 2025
What to do if Graco Water Pump output is low on both strokes?
- M
  Mrs. Donna MartinJul 31, 2025
  If your Graco Water Pump operates but has low output on both strokes, start by checking for a clogged fluid hose or valve and clear any obstructions. Ensure that the fluid supply isn't exhausted; if it is, refill it and reprime the pump. Also, inspect the valves and seals for wear or damage, and service them as necessary.
S
slongAug 4, 2025
Why is my Graco T2 having erratic operation?
- L
  Laura MossAug 4, 2025
  If your Graco Water Pump is experiencing erratic or accelerated operation, first check if the fluid supply is exhausted. If so, refill the fluid supply and reprime the pump. Another potential cause is a broken air motor compression spring, which would need to be replaced.
M
Matthew WilliamsAug 8, 2025
What to do if Graco T2 Water Pump output is low on the downstroke?
- K
  Kristy SmithAug 8, 2025
  If your Graco Water Pump operates, but the output is low on the downstroke, the intake valve may be held open or worn. Try clearing or servicing the valve. Also, worn or damaged valves or seals can cause this issue, so service them as needed.
R
Rachel MillerAug 13, 2025
What to do if Graco T2 output is low on the upstroke?
- M
  Maria JohnsonAug 13, 2025
  If your Graco Water Pump operates, but the output is low on the upstroke, the piston valve might be held open or worn. Clear or service the valve to resolve this. Additionally, worn or damaged valves or seals could be the cause, and these should be serviced.
D
David NavarroAug 17, 2025
Why does Graco T2 Water Pump slowly move after fluid shutoff in downstroke?
- K
  kwrightAug 17, 2025
  If your Graco Water Pump slowly moves after fluid shutoff in the downstroke, the intake valve check ball may be clogged or dirty. Clean the ball and seat to resolve this. It could also be caused by worn or damaged valves or seats, in which case you should install a repair kit.
S
sarah18Aug 21, 2025
Why does Graco T2 Water Pump slowly move after fluid shutoff in upstroke?
- W
  William YoungAug 21, 2025
  If your Graco Water Pump slowly moves after fluid shutoff in the upstroke, the lower piston ball or seat may be clogged or dirty. Try cleaning the ball and seat. Alternatively, worn or damaged valves or seats may be the cause, and you might need to install a repair kit.