Electro-pneumatic Control Panel Display Screens
Icon/Field Description
Ram Down
Momentarily press to lower the ram to the lowest position. The ram will continue
lowering until the ram has reached the bottom of its travel unless manually stopped.
Set Container
Top
Position the tote and use the manual controls to lower the ram plate into the tote until
the top lip of the ram plate is at the same height as the top lip of the tote. Press the Set
Container Top icon to store the position.
Set Container Low
Lower the ram
plate into the tote until the ram plate is at the height where the material
in the tote is
at a low level. Press the Set Container Low icon to store the position. This
setting will
control when the pumps go from fast pumping to slow pumping to finish
evacuating
the remaining product from the tote.
Set Container
Bottom
Lower the ram plate into the tote until the ram plate is at the bottom of the tote. Press
the Set Container Bottom icon to store the position. This setting will instruct the pump
to stop pumping, deflate the seal, and raise the ram plate if the auto raise function
has been selected.
This is a visual presentation of the ram plate position settings for this container recipe.
It will reflect the positions that have been saved for this recipe. If the value of a setting
has not yet been defined, the position of the ram plate, low level, or bottom oftote
indications may not be shown in the desired position on the graphic. The red line
indicates the location of the current low level position.
Save th
e current values displayed. If this screen is exited without saving, any changes
made to
thescreenarelost.
Return to the recipe list screen. If this screen is exited without saving, any changes
made to the screen are lost.
3A5416C 43
To Next Page
Loading...
