Graco SnugRide Click Connect 30 User Manual

27
1. Place the infant restraint without base in a rear-facing
position in a vehicle seat.
2. Thread the lap belt or lap portion of a lap/shoulder belt under both
vehicle belt hooks:
3. Buckle the vehicle belt.
4. Tighten the vehicle seat belt.
To create a secure installation, push
down hard with your free hand on
the infant restraint Ì and pull and
tighten the vehicle belt.
5. Check infant restraint is level: Red level
line on the warning label MUST be
level with the ground .
6. Test infant restraint for secure
installation as described in infant
restraint “Final Safety Check” page 42.
Lap Belt
Ì

Lap/Shoulder
Belt

Graco SnugRide Click Connect 30 Specifications

General

Weight Capacity	4-30 lbs
Height Capacity	Up to 30 inches
Harness Type	5-point harness
Base Included	Yes
Side Impact Protection	Yes
Infant Head Support	Yes
Category	Infant Car Seat
Car Seat Weight	7.5 lbs
Expiration	7 years from manufacture date
Recline Positions	Multiple
Stroller Compatible	Yes
Travel System Compatible	Yes
Warranty	1 year limited warranty
Installation Type	LATCH, Seat Belt
Installation Method	LATCH or Vehicle Seat Belt