30
1. MAKE SURE vehicle is on level ground. Make sure to check your
vehicle owner's manual for UAS seating
positions.
2. For ease of installation, press button to extend
UAS
to its MAXIMUM LENGTH
Ê
.
3. Position base in vehicle seat as shown.
4. Make sure UAS is through vehicle/UAS
belt path normally used for vehicle seat belt.
Ë
.
Belt must lie flat and not be twisted.
5. Attach connectors to vehicle lower anchors.
Pull firmly on connectors to be sure they
are attached Ì.
6. Tighten UAS by pushing down hard on
base and pulling the adjustment belt back
through belt path .
Ë
6.3 Using UAS to Install Base
Ê
Ì
CLICK!
To Next Page
Loading...
