Name: Graco SnugRide Click Connect 30
Brand: Graco
Rating: 5 (1 reviews)

To Next Page

To Previous Page

6.1 Installing the Infant Restraint Without

Base Using Vehicle Belt

6.0 How to Install the Infant Restraint/Base

You must carefully follow the instructions provided by your

vehicle manufacturer, in addition to the information in this

manual. Before proceeding be sure you have read and

understood section 4, “Choosing an Appropriate

Vehicle Seat Location” on pages 13-19.

Make sure the buckle tongue goes into the correct

buckle

. The seat belt should not be twisted

or turned.

Make sure vehicle is on level ground

so that the level indicator can be used to

properly recline the infant restraint.

Refer to your vehicle owner’s manual and

the instructions in “4.2.2 SAFE Vehicle Belt

Systems”, page 16-18, on tightening your

vehicle belt when using the infant restraint

without base.

If a front passenger seat is used (see air bag

warning, page 4), slide the vehicle seat

rearward as far as possible from the

dashboard. If a rear seat is used, make

sure the seat in front of it is moved forward enough and is upright

enough to allow room for the infant restraint.

Questions and Answers:

Need help?

Do you have a question about the Graco SnugRide Click Connect 30 and is the answer not in the manual?

Graco SnugRide Click Connect 30 Specifications

General