Graco SnugRide Click Connect 30 User Manual

35
1. Remove infant restraint
from base and rotate handle
down to sitting position.
See “5.1 Adjusting Handle” and
“5.2 Removing and Attaching
Infant Restraint”, page. 23.
2. Place child in seat as shown Ê.
3. Determine which pair of harness slots are even
with or just below your child’s shoulders Ë.
4. If the harness straps must be
adjusted: remove child from infant
restraint and move harness straps
to the proper harness slots by doing
the following:
FAILURE TO PROPERLY ADJUST THE HARNESS STRAPS FOR
YOUR CHILD INCREASES THE RISK OF SERIOUS INJURY OR
DEATH IN THE EVENT OF A SHARP TURN, SUDDEN STOP, OR
CRASH. The harness straps must be properly adjusted to fit your child
according to the following instructions.
7.0 Using Infant Restraint
7.1 Positioning Harness Straps
Ê
Use harness slots
even with or just below
child’s shoulders
Ë

Graco SnugRide Click Connect 30 Specifications

General

Weight Capacity	4-30 lbs
Height Capacity	Up to 30 inches
Harness Type	5-point harness
Base Included	Yes
Side Impact Protection	Yes
Infant Head Support	Yes
Category	Infant Car Seat
Car Seat Weight	7.5 lbs
Expiration	7 years from manufacture date
Recline Positions	Multiple
Stroller Compatible	Yes
Travel System Compatible	Yes
Warranty	1 year limited warranty
Installation Type	LATCH, Seat Belt
Installation Method	LATCH or Vehicle Seat Belt