31
7. NEVER put two UAS connectors on one
vehicle UAS anchor
.
8. Test infant restraint for secure installation as
described in infant restraint “Final Safety
Check” page 42.
9. Check that the UAS stays tight and does not
slip from the tightened position. If it does not stay
tight, try another seating position or contact
1-800-345-4109.
10. To remove UAS, push button while
pulling on the UAS belt as shown
.
11. Press and hold UAS release hinge
.
12. Push connector in, lift connector up and
pull out (away from anchor point)
.
13. Repeat steps 11 and 12 for other connector.
To Next Page
Loading...
