70
Sliding Latch Plate and
ELR Retractor
A latch plate that
slides freely on the belt
webbing and cannot, by
itself, hold the belt snug
around a car seat.
With this retractor, you
will need to use the
locking clip to lock the
vehicle seat belt.
Route the vehicle seat
belt through the proper
belt path and buckle it
in. Pull the vehicle seat
belt tight. While pushing
down on seat, pinch
the two straps together
behind the buckle
tongue. Unbuckle the belt
without allowing it to slip.
Attach locking clip to lap
and shoulder belts as
shown.
Buckle belt. Check that
lap belt does not move
by pulling hard. If belt
loosens or lengthens,
repeat procedure.
2.5 cm (1 in)
Note: When using the base, you
do not need to use the locking clip.
The lock-off locks the seat belt.
To Next Page
Loading...
