71
Grab the sides of the seat at the belt
path and slide side to side and front
to back. The base or seat should not
move more than 2.5 cm (1 in).
Locking Latch Plate and
No Retractor
When installing the car
seat, route the lap seat
belt through the proper
path and buckle it in.
Then, pull upwards on
the tail of the belt so that
the lap belt gets tight
around the car seat.
Sewn On Latch Plate and
ALR Retractor
Slowly pull the lap belt
all the way out. Route
the vehicle seat lap belt
through the proper belt
path and buckle it in.
Then, pull the lap belt
tight while feeding all
the slack back into the
retractor.
Grab the sides of the seat at the belt
path and slide side to side and front
to back. The base or seat should not
move more than 2.5 cm (1 in).
Lap Belt Installation
Always review your vehicle owner’s manual for specific
information about your vehicle seat belts.
To Next Page
Loading...
