Graco Super nova 495 - Cleanup Procedure; Initial Cleanup Steps; Flushing and Rinsing

Cleanup
12 309665L
Cleanup
1 Turn power OFF and
unplug sprayer
2 Turn pressure to lowest
setting. Trigger gun to
relieve pressure.
3 Put drain tube in pail.
Turn prime valve down.
4 Remove guard and
SwitchTip.
ti2707a
WASTE
WASTE
ti2599a
ti2614a
-
ti2719a
WASTE
RESÍDUOS
À JETER
DESECHO
ti2595a
ti2769a
5 Remove siphon tube set from
paint and place in flushing
fluid. Use water for water
base paint and mineral spirits
for oil base paint.
6 Plug in sprayer. Turn power
ON . Turn prime valve
horizontal.
7 Hold gun against paint pail.
Take trigger safety OFF.
Trigger gun and increase
pressure until flushing fluid
appears
8 Move gun to flushing pail,
hold gun against pail, trigger
gun to thoroughly flush
system. Release trigger and
put trigger safety ON.
WASTE
ti2712a
ti2810a
ti2707a
PAINT
ti2770a
ti2817a
WASTE
WASTE
ti2599a
9 Turn prime valve down and
allow flushing fluid to
circulate for 1 to 2 minutes
to clean drain tube.
10 Raise siphon tube above
flushing fluid and run sprayer
for 15 to 30 seconds to drain
fluid. Turn power
OFF
11 Close drain valve. Trigger
gun into flushing pail to purge
fluid from hose.
12 Open prime valve.
ti2719a
ti2707a
PAINT
FLUSH
ti2820a
ti2712a
WASTE
ti2713a
ti2719a