Table
of
Contents
Warnings
......................................
2
Setup
..........................................
6
Startup..
......................................
8
Shutdown and Care
...........................
10
Flushing
.....................................
11
Troubleshooting..
.............................
12
Spin Test .....................................
17
General Repair Information
.....................
18
Motor Brush Replacement
.....................
19
Power Supply Cord Replacement
...............
20
On/Off Switch Replacement
....................
21
Pressure Control Replacement
.................
22
Filter Board Replacement
......................
23
Bearing Housing &Connecting Rod Replacement
.
24
Drive Housing Replacement ....................
25
Motor Replacement
...........................
27
Displacement Pump Repair..
...................
29
Parts Drawing
-
Sprayer
.......................
34
Parts List
-
Sprayer
...........................
35
Parts Drawing and List
-
Displacement Pump ....
36
Parts Drawing
-
Pressure Control
...............
37
Parts List
-
Pressure Control
...................
37
Wiring Diagram
...............................
38
Accessories
..................................
39
Technical Data
................................
39
Dimensions
..................................
39
Graco Phone Numbers
........................
40
The Graco Warranty And Disclaimers
............
40
Symbols
Warninp
Svmbol
Caution
Symbol
This symbol alerts you to the possibility of serious
injury or death
if
you do not follow the instructions.
This symbol alerts you to the possibility of damage
to
or destruction of equipment
if
you do not follow the
instructions.
FIRE
AND
EXPLOSION HAZARD
Improper grounding, poor ventilation, open flames or sparks can cause a hazardous condition and
result in a fire or explosion and serious injury.
0
If
there is any static sparking or you feel an electric shock while using this equipment,
stop
spraying Immedlately.
Do
not use the equipment until you identi and correct the problem.
0
Provide fresh air ventilation
to
avoid the buildup of flammable fumes from solvents or the fluid
being sprayed.
0
Keep the spray area free of debris, including solvent, rags, and gasoline.
Electrically disconnect all equipment in the spray area.
Extinguish all open flames or pilot lights in the spray area.
0
Do not smoke in
the
spray area.
0
Do not turn on or
off
any light switch in the spray area while operating or
if
fumes are present.
Do not operate a gasoline engine in the spray area.
2
308-560