EQUIPMENT MISUSE
HAZARD
Equipment misuse can cause the equipment to rupture or malfunction and result in serious injury.
This
equipment
is
for professional use only.
Read all instruction manuals, tags, and labels before operating the equipment.
Use the equipment only for its intended purpose.
If
you are not sure, call Graco Technical Assis-
tance at
1-800-543-0339.
Do not alter or modify this equipment.
Check equipment daily. Repair or replace worn or damaged parts immediately.
Do
not exceed the maximum working pressure of the lowest rated system component. Refer to
the Technlcal Data on page
39
for the maximum working pressure of this equipment.
Use fluids and solvents which are compatible with the equipment wetted parts. Refer to the
Technical Data section of all equipmentmanuals. Read the fluid and solvent manufacturer’s
warnings.
Do not use
1,l.l
-trichloroethane, methylene chloride, other halogenated hydrocarbon solvents
or fluids containing such solvents in pressurized aluminum equipment. Such use could result in
a chemical reaction, with the possibility of explosion.
Do not use hoses to pull equipment.
Route hoses away from traffic areas, sharp edges, moving parts, and hot surfaces. Do not
ex.
pose Graco hoses to temperatures above
82°C
(180°F)
or below -40°C
(-40°F).
Do not
lii
pressurized equipment.
Comply with all applicable
local,
state, and national fire, electrical, and safety regulations.
Wear hearing protection when operating this equipment.
TOXIC
FLUID HAZARD
Hazardous fluid or toxic fumes can cause serious injury or death if splashed in the eyes or on the
skin, inhaled, or swallowed.
Know
the specific hazards of the fluid you are using.
Store hazardous fluid in an approved container. Dispose of hazardous fluid according to all
local, state and national guidelines.
Always wear protective eyewear, gloves, clothing and respirator as recommended by the fluid
and solvent manufacturer.
MOVING
PARTS
HAZARD
Moving parts, such as the air motor piston, can pinch or amputate your fingers.
B
Keep clear of all moving parts when starting or operating the pump.
B
Before servicing the equipment, follow the Pressure Relief Procedure on page
12
to prevent
the equipment from starting unexpectedly.
308-560
3
To Next Page
Loading...
