Fig.
I
04784
DC
motor,
220/240
Vac,
50
Hz,
EA,
1
phase
Controls fluid outlet pressure
Power switch that controls
220/240
Vac main power to sprayer
Transfers power from DC motor
to
the displacement pump
Final filter of fluid between source and spray gun
Second sDrav aun operation
is
connected here
.
"
Container for fluid
to
be
sDraVed mav be huna here
.~
Transfers fluid to be spraved from source through spray gun
-
~
1/4
in: IDgrounded, nylon hose with spring guards on both ends
Reverse-A-Clean
(RAG)
tip guard reduces risk of injection injury
High pressure spray gun with gun safety latch
RAC switch tip
uses
high pressure fluid to remove clogs from spray
tip without removing tip from spray gun
3/16
in.
ID,
grounded, nylon hose used between
50
fl
hose and
sDrav aun to allow more flexibilify when spraying
Single spray gun operation is connected here
Relieves fluid
outlet
pressure when open
Controls motor speed
to
maintain fluid outlet pressure at displace-
ment Dump oulet. Works with Pressure adjusting knob.
Gun safety latch inhibits accidental triggering of spray gun
U
I
PressureGauge
I
Fluid pressure reference
I
308-560
5
To Next Page
Loading...
