To Next Page
F
fharrisJul 31, 2025
What to do if the Graco Industrial Equipment program does not start?
- AAmy RodriguezJul 31, 2025
If the Graco program isn't starting, here are a few things to check: * First, ensure that the power is on. * Make sure cable 118342 and any adapters are fully seated at both the PC and the connected ports. * See if any other programs are using the same PC communication port. Communication conflicts often occur with fax and handheld computer software, so close or deactivate any potentially conflicting software. * You can also try switching to another PC communication port. * If you're using Hyper Terminal, try closing and restarting it. * Press the PC Enter key multiple times to see if the main menu appears. * To isolate the problem, try communicating with a different PC, RS-232 cable, or ProMix Easy, XtremeMix or XtremeMix 185 system, if available.
General
