Graco Xtreme Mix 185 User Manual

Graco Inc. P.O. Box 1441 Minneapolis, MN 55440-1441
Copyright 2004, Graco Inc. is registered to I.S. EN ISO 9001
310665E
Operation
Plural Component Proportioner
Important Safety Instructions
Read all warnings and instructions in this manual.
Save these instructions..
TI4912b
TI5112a
Non-heated Un
i
ts
Heated Units
United States, Patent No. 6,896,152

Graco Xtreme Mix 185 Specifications

General

Brand	Graco
Model	Xtreme Mix 185
Category	Industrial Equipment
Language	English

Summary

Operation

Important Safety Instructions

Read all warnings and instructions before operating the equipment.

Xtreme Mix 185 Model Specifications

General Safety Warnings

Fire, Explosion, and Moving Parts Hazards

Addresses risks from flammability, ignition sources, and hazardous moving equipment parts.

Skin Injection and Burn Hazards

Warns about high-pressure fluid injection injuries and burn risks from hot surfaces/fluids.

Operational and Material Hazards

Equipment Misuse and Recoil Hazards

Covers risks from improper operation, modification, and gun recoil.

Toxic Fluid, Fumes, and PPE

Details hazards from toxic materials and lists essential personal protective equipment.

Overview and User Interface

User Interface Controls

Explains the function knob, buttons, display, and data port of the user interface.

Installation Procedures

Fluid System Components

Proper Lifting Technique

Provides safety guidelines and steps for lifting the equipment to prevent injury.

Initial Setup and Grounding

Grounding the Equipment

Instructions for connecting the equipment to a true earth ground for safety.

System Configuration and Preparation

Ratio Setup Procedure

Pressure Relief Procedures

Fluid Manifold to Gun Relief

Details the procedure to relieve pressure from the fluid manifold to the gun.

Pump Pressure Relief

Pump to Fluid Manifold Relief

Explains how to relieve pressure from the pump to the fluid manifold.

Flushing Procedures

Fluid Manifold Flushing

Full System Flushing Details

Component Flushing (A & B)

Priming the System

Priming Component A

Priming Component B and Final Steps

Priming Component B

Pump Performance Testing

Pump Test Procedure (Fluid A)

Details dispensing fluid A and performing the pump stall test.

Pump Test Procedure (Fluid B)

Details dispensing fluid B and performing the pump stall test.

Spraying Operation

Pre-Spray Preparations

Spray Pattern Adjustment

Mix and Integration Testing

Butterfly Test for Mix Quality

Describes dispensing material without a tip to check for unmixed material.

Curing Test for Dry Time

Appearance Test for Catalysis

Batch Dispense and Ratio Check

Batch Dispense Procedure

Ratio Check Procedure

Shutdown Procedures

Prolonged Shutdown Preparation

System Recalibration

Set Pump Calibration Value

Guides on noting the current calibration value and setting it in the system.

Calibrate Pump Sensor

Details the steps to calibrate the pump sensor for accurate operation.

Alarm Codes and Troubleshooting

Startup Alarm Codes

Lists and explains error codes that occur during equipment startup.

Operating Alarm Codes

Lists and explains error codes that occur during normal operation.

Testing Error Alarms

Testing Error Codes

Details specific error codes related to pump stall tests and calibration timeouts.