10
INSTALLATION
1. Remove the package from the carton.
2. Remove the pan from the cardboard.
3. Remove the AC/Adaptor (it is inside a white box).
4. Take out the balance from its protection and place it on its definitive place
of use, which should be a flat, non-metallic, most stable and rigid surface.
5. Put the stainless steel pan on the pan support.
6. Level the balance by turning the four adjustable feet until the bubble
level located on left frontal side remains in the centre of the circle.
7. Connect the AC/Adaptor to the balance´s connector and then to an outlet
of 220/240 V. 50 Hz.
8. Calibrate the balance with a proper calibration weight. This action is very
important in order to obtain accurate weighing results.
9. For maximum accuracy, it is necessary to keep the balance connected
for about 60 minutes before using it. However, the balance can also be
used immediately with good results.
To Next Page
Loading...
Need help?
General
