16
Electronic Control
The fridge/freezer is equipped with electronic control. The control
panel is concealed behind the refrigerator door. The appliance has
been factory set to operate at optimum temperature, i.e. +5ºC in
the refrigerator’s chamber and –18ºC in the freezers chamber.
If you wish to change the preset temperature, the new setting will
be stored in the electronic control. In case of power failure, the
control will remember the latest setting when the power to the
cabinet is restored.
The electronic control has the following functions:
- On/Off switch function.
- Display of the real temperature inside the refrigerator’s and
freezer’s chambers.
- Setting the temperatures in the refrigerator’s and freezer’s
chambers.
- Automatic defrosting of the refrigerator’s chamber.
- Quick freezing.
- Quick refrigeration.
- Vent function inside the refrigerator’s chamber.
- Adjustment of the display contrast.
- Acoustic and visual signalling of alarms.
- Visual signalling with use of LED’s of switched on functions.
Operating the fridge/freezer
Start the fridge/freezer by plugging it into a wall socket.
If the mains lead has been damaged, it must be replaced with a
corresponding type supplied by an electrical service centre and
installed by a qualified electrician.
The fridge/freezer incorporates a “stand-by function” and in the
display two horizontal lines indicate that the power supply has
been connected.
- Start the refrigerator compartment by pressing the upper on/off
button
o (2). After approx. 5 seconds, the green light-emitting
LED (3) lights up to indicate that the refrigerating compartment is
switched on. The actual temperature inside the refrigerator’s
compartment is shown on the display (7).
To Next Page
Loading...
Need help?
General
