22
ALARMS
Normal use of the fridge/freezer may cause different situations
leading to interruption of various functions and unstable operation
of the entire equipment as a consequence. These interruptions are
shown on the display as the alarm code (an “E” followed by a
number) and signalled by the acoustic alarm. In case of several
faults, the alarm codes will be displayed in turn.
Alarm codes
E1 - temperature sensor fault in the refrigerator’s chamber.
E2 - temperature sensor fault in the freezer’s chamber.
One of the temperature sensors has been damaged. Call your
supplier. The built-in emergency program maintains the admissible
temperature until the fault can be eliminated by the authorized
technical service.
E4 - door is open
The door of the refrigerator’s chamber has been opened for more
than 3 minutes. The alarm code disappears when the door is
closed.
E5 - the temperature inside the freezer’s chamber has been
higher than the set temperature for more than 2 hours.
E6 - temperature too high at power failure
There has been a power failure or has been disconnected and the
temperature has been higher than the set temperature for more
than 2 hours.
Interrupting an alarm
The acoustic alarm can always be interrupted by opening the door
and pressing any button. The alarm code will remain displayed
until the alarm has been cancelled. A 2 hour silence will follow.
The alarm codes E4, E5, E6 can be cancelled by pressing for 7-8
seconds simultaneously, the buttons (8) and (9).
The exception: in case of the alarm E1 or E2 it is possible to cancel
the alarm only after replacing damaged sensors.
In such cases please contact your supplier.
To Next Page
Loading...
Need help?
General
