Door Relay Options
There are three choices in the pull-down selection: Local
Relay, Webrelay and GSC3570.
● Local Relay: Local Relay is the GDS3705 controlling the
relay. The strike is wired into the COM2 or COM1 port of
the GDS3705 depending 1 door or 2 door need to be
controlled.
● Webrelay: When Webrelay is selected, customers need to
continue configure the webrelay IP address or domain
name, together with credentials like Username and
Password. When legal open door event happened, the
configured web relay will get the communication from
GDS3705, and will operate the strike to open door for the
authenticated open door request.
● GSC3570 Relay: When the Door relay is set to GSC3570,
it gives the option to connect it to the GSC3570 device by
entering the Phone number and door password
Note: In web relay mode, the strike is wired to the web relay
controller device.
Webrelay On URL When Door relay Option set to Webrelay, then enter the
correct URL used by the third party controller so that the
GDS370x send the command to activate the relay.
This adds an extra layer of security so when legal open door
event happened, the configured web relay will get the
communication from GDS370x, and will operate the strike to
open door for the authenticated open door request or use
that command to operate other industry application.
Notes:
● Now there are two Webrelay URL fields available, with On
or Off URL command allowed or other usage URL
command allowed. Also allow Username and Password
configured if the 3rdparty Webrelay requiring this
security feature.
● If some 3rd party Webrelay only support one URL
command, then just leave another Off URL blank, or put
whatever there as long as it is NOT a URL command.
To Next Page
Loading...
Need help?
General
