Grandstream Networks GDS370 Series User Manual

Webrelay Off URL
When Door relay Option set to Webrelay, then enter the
correct URL used by the 3rd party controller so that the
GDS3705 send the command to disable the relay.
Webrelay Username Enter the web relay username.
Webrelay Password Enter the web relay password.
ALMOUT1 Feature
This option allows to choose to use Alarm_Out (COM1)
interface for either as alarm out with 3rd party device, or to
control a second door “Door 2” (the two functions are mutual
exclusive).
When option “Open Door” is selected, will enable GDS3705 to
control the operation of two doors via RFID, local and remote
PINs.
ALMOUT1 Status
Select Normal Open or Normal Close depending on the lock
used.
Delay before Unlock (s)
Device will open door after specified delay (in seconds) when
user issuing the authorization.
Unlock Holding Time (s)
Configures the lock holding time, in seconds (default value is
5 seconds).
Device will hold the door unlocked for this specified duration.
Range: 1-1800 seconds.
Minimum Interval of Swiping Card (ms)
Defines the interval in ms to swipe consecutive RFID cards.
The range should be between 0ms and 2000ms. Default 300
ms.
Note: Configuration available only on the GDS3705.
GSC3570 Phone Number
Incase of choosing a GSC3570 Relay , the Phone number of
the GSC3570 needs to be defined on this field.
GSC3570 Door Password
Incase of choosing a GSC3570 Relay , the Door Password of
the GSC3570 needs to be defined on this field.
Call Mode
Chooses whether to make call to the SIP number or Virtual
Number when dialing from the GDS3705 keypad.
Note: Configuration only for the GDS3705 Model.
Doorbell Mode
Configures the action to be taken when the doorbell is
pressed, three options are available:
● Call Doorbell Number:when Doorbell is pressed, a call will
be made to the “Number Called When Door Bell
Pressed”.*This option will be the only available when
ALMOUT1 Feature is set to Open Door.
● Control Doorbell Output (Digital Output 1): when Door Bell
is pressed electronic lock for Output 1 is opened.
● Both of Above: When selected, both Call Doorbell Number
and Control Doorbell Output options are enabled.
Doorbell Call Out Account
This option sets the account to be used to make call upon
thedoorbell trigger. If set to Auto, the GDS will use the first
available account.
Door Bell Call Mode Select the ring strategy for the Numbers Called when

Grandstream Networks GDS370 Series Specifications

General

Brand	Grandstream Networks
Model	GDS370 Series
Category	Intercom System
Language	English