Grandstream Networks GDS370 Series User Manual

pressing the Door Bell button to be either Serial or Parallel:
● Serial Hunting: the configured extensions and/or IP
addresses will ring one after one by order.
● Parallel Hunting: The configured extensions and/or IP
addresses will ring simultaneously (up to 4 simultaneous
SIP calls).
Press Doorbell Schedule 1
Sets the first doorbell schedule , the device will verify if
current time fits in the schedule , if yes it will dial out using
the configured number in the field "Number 1 Called When
Doorbell Pressed"
Number 1 Called When Door Bell Pressed
Configures SIP extension number (SIP Server mode), or IP
address with port number (peering mode), to be called when
the Door Bell is pressed:
● SIP Server Mode:
○ The field can be configured to store multiple one or
multiple SIP extensions, if configured with multiple
extensions (ex: 1001, 1002, 1003), separated with “,” the
GDS3705 will ring one extension after the other in a
Serial Hunting Mode (GDS will ring each extension by
default 15 seconds, this can be changed on the Ring
Timeout) or ring them simultaneously in Parallel Hunting
Mode.
○ When using UCM, users can also configure there a Ring
Group extension (6400 for example) that will ring
multiple extensions simultaneously, or one by one
depending on the Ring Group ring strategy
○ If all phones are GXP21XX, users can open door either by
pressing Remote_PIN# or by pressing Open Door button
if already configured.
○ If early medial is enabled on phone side, user can send
the PIN code using the Open-Door button before
answering the call (Of course users can open the door
also after answering the call).
● Peering Mode:
○ User should configure multiple IP addresses of phones
instead of SIP extensions, when Door Bell pressed the
GDS3705 will ring the configured IP Addresses in Serial
or Parallel Mode according to Doorbell Call Mode
strategy.
Note: This field supports a Maximum of 256 characters.
Note: The latest firmware version 1.0.3.11 now supports
configuring different "Number Called When Door Bell
Pressed" entries depending on the time frame.
Press Doorbell Schedule 2
Sets the second doorbell schedule , the device will verify if
current time fits in the schedule , if yes it will dial out using
the configured number in the field "Number 2 Called When
Doorbell Pressed"
Number 2 Called When Door Bell Pressed Configures SIP extension number (SIP Server mode), or IP
address with port number (peering mode), to be called when
the Door Bell is pressed:
SIP Server Mode:
The field can be configured to store multiple one or multiple
SIP extensions, if configured with multiple extensions (ex:
1001, 1002, 1003), separated with “,” the GDS370x will ring
one extension after the other in aSerial Hunting Mode(GDS

Grandstream Networks GDS370 Series Specifications

General

Brand	Grandstream Networks
Model	GDS370 Series
Category	Intercom System
Language	English