To Next Page

To Previous Page

P a g e | 77

GRP261x/GRP2624/GRP2634 Administration Guide

Version 1.0.5.48

The default setting is “Toggle”.

Settings  Programmable Keys  Virtual Multi-Purpose Keys

Mode

Assigns a function to the corresponding line key. The key mode options are:

 None

 Default

Regular line key to open up a line and switch line. The Value field can

be left blank.

 Shared

Share line for Shared Line Appearance feature. Select the Account

registered as Shared line for the line key. The Value field can be left

blank.

Note: Users can either show or hide VPK shared line display description,

This only can be done with provisioning using the Pvalue P8484 (Value

= 0; No . Value = 1; Yes)

 Speed Dial

Select the Account to dial from. And enter the Speed Dial number in the

Value field to be dialed, or enter the IP address to set the Direct IP call

as Speed Dial.

 Busy Lamp Field (BLF)

Select the Account to monitor the BLF status. Enter the extension

number in the Value field to be monitored.

 Presence Watcher

This option has to be supported by a presence server and it is tied to the

“Do Not Disturb” status of the phone’s extension.

 Eventlist BLF

This option is similar to the BLF option but in this case the PBX collects

the information from the phones and sends it out in one single notify

message. PBX server has to support this feature.

 Speed Dial via active account

Similar to Speed Dial but it will dial based on the current active account.

For example, if the phone is offhook and account 2 is active, it will call

the configured Speed Dial number using account 2.

 Dial DTMF

Enter a series of DTMF digits in the Value field to be dialed during the

call. “Enable MPK Sending DTMF” has to be set to “Yes” first.

Grandstream Networks GRP261 Series Administration Guide

Other manuals for Grandstream Networks GRP261 Series