Grandstream Networks GWN7610 Master/Slave Architecture Guide

P a g e | 11
GWN76xx Master/Slave Architecture Guide
Security Mode
Set the security mode for encryption, 5 options are available:
 WEP 64-bit: Using a static WEP key. The characters can only be
0-9 or A-F with a length of 10, or printable ASCII characters with a
length of 5.
 WEP 128-bit: Using a static WEP key. The characters can only be
0-9 or A-F with a length of 26, or printable ASCII characters with a
length of 13.
 WPA/WPA2: Using “PSK” or “802.1x” as WPA Key Mode, with
“AES” or “AES/TKIP” Encryption Type.
 WPA2: Using “PSK” or “802.1x” as WPA Key Mode, with “AES” or
“AES/TKIP” Encryption Type. Recommended configuration for
authentication.
 Open: No password is required. Wireless clients will be connected
without authentication. Not recommended for security reasons.
Use MAC Filtering
Choose Blacklist/Whitelist to specify MAC addresses to be
excluded/included from connecting to the Wi-Fi zone. Default is Disabled.
Client Isolation
Client isolation feature blocks any TCP/IP connection between connected
clients to GWN76xx’s Wi-Fi access point. Client isolation can be helpful to
increase security for Guest networks/Public Wi-Fi.
If enabled, the default LAN Gateway’s MAC address must be specified
under Gateway MAC Address field. The clients will not be able to
discover, ping or access other wireless devices connected to GWN7600’s
network groups and only access to the default gateway, which usually
means Internet access.
If disabled, clients will have full access to any device connected to the
network, including wireless clients across network groups.
Default is “Disabled”.
Gateway MAC Address
This field is required when using Client Isolation, so users will not lose
access to the Network (usually Internet).
Type in the default LAN Gateway’s MAC address (router’s MAC address
for instance) in hexadecimal separated by “:”.
Example: 00:0B:82:8B:4D:D8
RSSI Enabled
Check to enable RSSI function, this will lead the AP to disconnect users
below the configured threshold in Minimum RSSI (dBm).
Minimum RSSI (dBm)
Enter the minimum RSSI value in dBm. If the signal value is lower than the
configured minimum value, the client will be disconnected. The input range
is from “-94” or “-1”.

Grandstream Networks GWN7610 Specifications

General

Brand	Grandstream Networks
Model	GWN7610
Category	Wireless Access Point
Language	English