FIRMWARE VERSION 1.0.4.23 GXP1400/GXP1405 USER MANUAL Page 15 of 60
For example: If 2 independent accounts are registered on GXP1400/GXP1405, when LINE 1 is pressed,
the LINE 1 LED will light up in green. If LINE 2 is pressed, the LINE 2 LED will light up in green and the
subsequent call will be made through SIP account 2.
Incoming calls to a specific account will attempt to use its corresponding LINE if it is not in use. When the
“virtually” mapped line is in use, the GXP1400/GXP1405 will flash the other available LINE in red. A line is
ACTIVE when it is in use and the corresponding LED is red.
COMPLETING CALLS
There are several ways to complete a call on GXP1400/GXP1405.
• On hook dialing. Enter the number when the phone is on hook and then send out.
When the phone is in idle, enter the number to be dialed out;
Take handset off hook; or
Press Speaker button; or
Press Headset button with headset plugged in; or
Select an available LINE key;
The call will be dialed out.
• Off hook and dial. Off hook the phone, enter the number and send out.
Take handset off hook; or
Press Speaker button; or
Press Headset button with headset plugged in; or
Press an available LINE key to activate speaker;
You shall hear dial tone after off hook;
Enter the number;
Press SEND key or # to dial out.
• Redial. Redial the last dialed number.
Take handset off hook; or
Press Speaker button; or
Press Headset button with headset plugged in; or
Press an available LINE key to activate speaker; or
When the phone is in idle;
Press SEND key, or the REDIAL softkey.
• Via Call History. Dial the number logged in phone's call history.
To Next Page
Loading...
Need help?
General
