FIRMWARE VERSION 1.0.4.23 GXP1400/GXP1405 USER MANUAL Page 39 of 60
setting is "Medium".
Conference URI
Configures the conference URI when using Broadsoft N-
feature.
Use Privacy Header
Controls whether the Privacy Header will present in the SIP INVITE
message or not. The default setting is "default", which is when "Huawei
on, the Privacy Header will not show in INVITE. If
set to "Yes", the Privacy Header will always show in INVITE. If set to
"No", the Privacy Header will not show in INVITE.
Use P-Preferred-Identity
Header
Controls whether the P-Preferred-Identity Header will present in the SIP
INVITE message or not. The default setting is "default", which is when
"Huawei IMS" special feature is on, the P-Preferred-
not show in INVITE. If set to "Yes", the P-Preferred-Identity Header will
always show in INVITE. If set to "No", the P-Preferred-
will not show in INVITE.
Special Feature
Different soft switch vendors have special requirements. Therefore users
may need select special features to meet these requirements. Users can
choose from Standard, Nortel MCS, Broadsoft, CBCOM, RNK, Sylantro
or Huawei IMS depending on the server type. The default setting is
"Standard".
SETTINGS/BASIC SETTINGS PAGE
End User Password
Allows the administrator to set the password for user-
access. This field is case sensitive with a maximum length of 30
characters.
Confirm Password Confirms the end user password field to be the same as above.
Internet Protocol Selects Prefer IPv4 or Prefer IPv6.
IPv4 Address Type
Allows users to configure the appropriate network settings on the phone
to obtain IPv4 address
. Users could select "DHCP", "Static IP" or
"PPPoE". By default, it is set to "DHCP".
DHCP Host name (Option 12)
Specifies the name of the client. This field is optional but may be
required by some Internet Service Providers.
DHCP Vendor Class ID
(Option 60)
Used by clients and servers to exchange vendor class ID.
Allow DHCP Option 120 to
override SIP Server
Enables DHCP Option 120 from local server to override the SIP Server
on the phone. The default setting is "No".