FIRMWARE VERSION 1.0.4.23 GXP1400/GXP1405 USER MANUAL Page 40 of 60
PPPoE Account ID Enter the PPPoE account ID.
PPPoE Password Enter the PPPoE Password.
PPPoE Service Name Enter the PPPoE Service Name.
IPv4 Address Enter the IP address when static IP is used.
Subnet Mask Enter the Subnet Mask when static IP is used for IPv4.
Gateway Enter the Default Gateway when static IP is used for IPv4.
DNS Server 1 Enter the DNS Server 1 when static IP is used for IPv4.
DNS Server 2 Enter the DNS Server 2 when static IP is used for IPv4.
Preferred DNS Server Enter the Preferred DNS Server for IPv4.
IPv6 Address Type
Allows users to configure the appropriate network settings on the phone
to obtain IPv6 address. Users could select "Auto-
"Statically configured" for the IPv6 address type.
Static IPv6 Address
Enter the static IPv6 address when Full Static is used in "Statically
configured" IPv6 address type.
IPv6 Prefix Length
Enter the IPv6 prefix length when Full Static is used in "Statically
configured" IPv6 address type.
IPv6 Prefix
Enter the IPv6 Prefix (64 bits)
when Prefix Static is used in "Statically
configured" IPv6 address type.
DNS Server 1 Enter the DNS Server 1 for IPv6.
DNS Server 2 Enter the DNS Server 2 for IPv6.
Preferred DNS server Enter the Preferred DNS Server for IPv6.
802.1x mode
A
llows the user to enable/disable 802.1x mode on the phone. The
default value is disabled. To enable 802.1x mode, this field should be set
to EAP-MD5.
Identity Enter the Identity for the 802.1x mode.
MD5 Password Enter the MD5 Password for the 802.1x mode.
HTTP Proxy
Specifies the HTTP
proxy URL for the phone to send packets to. The
proxy server will act as an intermediary to route the packets to the
destination.
HTTPS Proxy
Specifies the HTTPS proxy URL for the phone to send packets to. The
proxy server will act as an intermediary to route the packets to the
destination.
Line Key X
Assigns a function
to the corresponding line key. The key mode options
are:
• Line
Regular line key to open up a line and switch line. The N