GXP16XX Administration Guide
Version 1.0.4.100
on the firmware server.
If configured, only the firmware file with the matching postfix will be
downloaded.
Choose whether to send syslog messages over UDP or secured SSL/TLS
connection. Default is UDP.
Notes:
• User can upload the CA file under MaintenanceSecurity settings.
• A reboot is required in order for the changes to take effect.
The URL or IP address of the syslog server for the phone to send syslog to.
Selects the level of logging for syslog. The default setting is "None".
There are 4 levels: DEBUG, INFO, WARNING and ERROR.
Syslog messages are sent based on the following events:
• product model/version on boot up (INFO level);
• NAT related info (INFO level);
• sent or received SIP message (DEBUG level);
• SIP message summary (INFO level);
• inbound and outbound calls (INFO level);
• registration status change (INFO level);
• negotiated codec (INFO level);
• Ethernet link up (INFO level);
• SLIC chip exception (WARNING and ERROR levels);
• Memory exception (ERROR level).
Note: Syslog messages includes also MAC address and firmware version.
Configures syslog message to be filtered based on keywords provided. If
multiple keywords are filled, it should be separated by “,”.
Note: No spaces allowed.
Configures whether the SIP log will be included in the syslog messages or not.
The default setting is "No".
Selects display language on the phone.
Specifies the language file postfix for downloaded language.
Specifies action URL for signal to be sending out when phone finished setting
up processes.
Specifies action URL for signal to be sending out when phone successfully
registered.
Specifies action URL for signal to be sending out when phone successfully
To Next Page
Loading...
Need help?
General
