P a g e | 17
HT813 Administration Guide
Version 1.0.1.2
CONFIGURATION GUIDE
The HT813 can be configured via one of two ways:
The IVR voice prompt menu.
The Web GUI embedded on the HT813 using PC's web browser.
Obtain HT813 IP Address via Connected Analogue Phone
HT813 is by default configured to obtain the IP address from DHCP server where the unit is located. To
know which IP address is assigned to your HT813, you should access to the “Interactive Voice Response
Menu” of your adapter via the connected phone and check its IP address mode.
Please refer to the steps below to access the interactive voice response menu:
1. Use a telephone connected to FXS port of your HT813.
2. Press *** (press the star key three times) to access the IVR menu and wait until you hear “Enter
the menu option “.
3. Press 02 and the current IP address will be announced.
Understanding HT813 Interactive Voice Prompt Response Menu
The HT813 has a built-in voice prompt menu for simple device configuration which lists actions, commands,
menu choices, and descriptions. Connect analog phone to FXS port. Pick up the handset and dial “***” to
use the IVR menu.
Table 5: Voice Prompt Menu
Press “*” for the next menu option
Press “#” to return to the main menu
Enter 01-05, 07,10, 12-17,47 or 99 menu options
“DHCP Mode”,
“Static IP Mode”
“PPPoE Mode“
Press “9” to toggle the selection
If using “Static IP Mode”, configure the IP address
information using menus 02 to 05.
If using “Dynamic IP Mode”, all IP address information
comes from the DHCP server automatically after reboot.
If using “PPPoE Mode”, configure PPPoE Username
and Password from web GUI to get IP from your ISP.
https://arttel.ru/
https://arttel.ru/shop/voip-shlyuzy/grandstream-ht-813
To Next Page
Loading...
Need help?
General
