P a g e | 20
HT813 Administration Guide
Version 1.0.1.2
Accessing the Web UI
- Via WAN port
1. You may check your HT813 IP address using the IVR on the connected phone.
Please see Obtain the HT813 IP address via the connected analogue phone
2. Open the web browser on your computer.
3. Enter the HT813’s IP address in the address bar of the browser.
4. Enter the administrator’s password to access the Web Configuration Menu.
Note: The computer must be connected to the same sub-network as the HT813. This can be easily done
by connecting the computer to the same hub or switch as the HT813.
- Via LAN port
1. Power your HT813 using PSU with the right specifications.
2. Connect your computer or switch directly to your HT813 LAN port.
3. Open the web browser on your computer.
4. Enter the default LAN IP address (192.168.2.1) in the address bar of the browser.
5. Enter the administrator’s password to access the Web Configuration Menu.
6. Make sure to reboot your device after changing your settings to apply the new configuration.
Note: Please make sure that your computer has a valid IP address on the range 192.168.2.x so you can
access the web GUI of your HT813.
Web UI Access Level Management
There are three default passwords for the login page:
Only Status and Basic Settings
Only checking. Not allowed to modify content.
The password is case sensitive with maximum length of 25 characters. When changing any settings, always
submit them by pressing Update or Apply button on the bottom of the page. After submitting the changes
in all the Web GUI pages, if a reboot is required, the web page will prompt the user to reboot by offering a
https://arttel.ru/
https://arttel.ru/shop/voip-shlyuzy/grandstream-ht-813
To Next Page
Loading...
Need help?
General
