P a g e | 25
HT813 Administration Guide
Version 1.0.1.2
Configures viewer level password.
Case sensitive and max. Length of 25 characters
Re-enter the viewer password to confirm change viewer password on web GUI to avoid
typo or mistakes.
Configure timer to logout web session during idle.
Default is 10 min. Range is 2-60 min.
Configure attempt limit before lockout.
Default is 5. Range is 1-10.
If login attempt failed 5 times, login would be locked out for the time length.
Default 15 mins. Range 1-15 min.
Allows users to choose the Web Access Mode between “HTTPS” and “HTTP”. If
“HTTPS” is selected, web UI will be accessed using HTTPS. Default is “HTTP”.
Customizes HTTP port used to access the HT813 web UI. Default is 80.
Customizes HTTPS port used to access the HT813 web UI. Default is 443.
Enables/disables the SSH access. Default is No (disabled).
Allows users to self-configure SSH Port number. By default, the port number is 22.
Enables/disables the Telnet access. Default is Yes (disabled).
Allows users to self-configure Telnet Port number. By default, the port number is 23.
Enables/Disables the Web and SSH access through the WAN port. The available
options are the following:
No: WAN side access for the Web GUI and SSH is disabled.
Yes: WAN side access for the Web GUI and SSH is enabled.
Auto: WAN side access allowed for private IP; rejected for public IP.
Default setting is Auto.
Allows users to configure the white List for WAN Side to be used for remote
management. Multiple IPs are supported and need to be separated by “space”.
Example: 192.168.5.222 192.168.5.223 192.168.7.0/24
https://arttel.ru/
https://arttel.ru/shop/voip-shlyuzy/grandstream-ht-813
To Next Page
Loading...
Need help?
General
