P a g e | 27
HT813 Administration Guide
Version 1.0.1.2
Exchanges vendor class ID by clients and servers to convey particular configuration or
other identification information about a client. Default is HT8XX.
Defines the PPPoE username. Necessary if ISP requires you to use a PPPoE (Point
to Point Protocol over Ethernet) connection.
Specifies the PPPoE account password.
Defines PPPoE service name. If your ISP uses a service name for the PPPoE
connection, enter the service name here. This field is optional. Default is blank.
Specifies preferred DNS server to use when DHCP or PPPoE are set.
Selects time zone to define date/time on the device.
Allows users to define their own time zone.
Allow DHCP server
to set Time Zone
Obtains time zone setting (offset) from a DHCP server using DHCP Option 2; it will
override selected time zone. If set to “No”, the analogue adapter will use selected time
zone even if provided by DHCP server. Default is Yes.
Configures the languages of the voice prompt and web interface, except Spanish that
it is only in IVR. Available languages: English, Chinese or Spanish IVR.
NAT/DHCP Server Information & Configuration
Controls whether the device is working in NAT router, Bridge or WAN Only mode.
NAT Router: In this mode, WAN port acts as DHCP client. LAN port is used
as DHCP Base IP; devices connected behind LAN port will be assigned an IP
from HT813 DHCP Server.
Bridge: In this mode, WAN port acts as DHCP client and pass-through to LAN
port; devices connected behind LAN port will get an IP from your network
DHCP server (same as WAN port).
WAN Only: In this mode, only WAN port is active. LAN port is not used.
Default mode is NAT Router.
Save the setting and reboot prior to configuring the HT813.
Defines the number of ports that can be managed while in NAT router mode.
Range: 0 – 4096, default is 1024. Typically, one port per connection
https://arttel.ru/
https://arttel.ru/shop/voip-shlyuzy/grandstream-ht-813
To Next Page
Loading...
Need help?
General
