19
Operation
The graphics or overview mode appears when no key
has been press for 2 minutes, or when the main menu is
exited by pressing “esc“.
The up and down buttons are used to scroll through the
list of sensors and relays .
You can enter the Main menu by pressing the „esc“ key.
The following menus are available:
Current temperature values with explanations
Function control of the system with operating hours,
etc
Automatic mode, manual mode or switch unit off
Set parameters needed for normal operation
E.4. - Menu sequence and menu structure
Solar and frost protection, recooling, anti-seizing
protection
Program selection, sensor calibration, clock,
additional sensor, etc.
Against unintentional setting changes at critical
points
For diagnosis in the event of an error
Language selection
1. Measurements
2. Statistics
3. Operating mode
4. Settings
5. Protections
6. Special functions
7. Menu lock
8. Service Data
9. Language
To Next Page
Loading...