44
Caution
This menu is used to set the current time and date.
When this function is active, the controller’s clock changes automatically to and from DST (DST, Daylight
Savings Time).
6.15. - Time and date
6.16. - Daylight saving time
For analysis of the system data it is essential for the time to be set accurately on the
controller. Please note that the clock does not continue to run if the mains voltage is
interrupted, and must therefore be reset.
When active, the displays backlight is switched off after 2 minutes of inactivity.
6.17. - Sleep mode
Caution
If a message is waiting, the backlight is not switched off.
This menu is used to select the temperature unit that is displayed.
6.18. - Temperature unit
Special functions
6.19. - Network
6.19.1. - Access Control
6.19.2. - Ethernet
In this menu, the settings of the Ethernet connection of the data logger are set.
Activate oder deactivate the ethernetfunction.
6.19.2.1. - Ethernet
6.19.2.2. - MAC Adress
6.19.2.3. - Auto-Confi guration (DHCP)
6.19.2.4. - IP-Adress
6.19.2.5. - Subnetz
6.19.2.6. - Gateway
6.19.2.7. - DNS-Server
In this menu, the settings of the ethernet connection of the data logger can be set.
Displays the individual MAC address of the data logger.
In this menu, the IP of the gateway for the data logger can be set.
In this menu, the IP address of the data logger can be set.
In this menu you can add or remove four users who should have access to the data logger. ITo add a user in
the list, select <add user>. The list show you the last 5 users that tried to connect to the data logger. Select a
user with OK to give it to grant access. To revoke access again choose one of the 4 users from your list and
choose <remove user>.
If activated, the datalogger requests IP adresses and network parameters from a DHCP server.
In this menu the subnet mask of the data logger can be set.
In this menu, the IP address of the DNS server can be set.
To Next Page
Loading...