9
Installation
Install the controller only in dry areas and under the ambient conditions described under B.1
“Speci cations”.
1. Unscrew cover screw completely
2. Carefully pull upper part of housing from lower
part.
3. Set upper part of housing aside, being sure not to
touch the electronics when doing so.
4. Hold the lower part of the housing up to the
selected position and mark the 3 mounting holes.
Make sure that the wall surface is as even as possible
so that the housing does not become distorted when
it is screwed on.
5. Using a drill and size 6 bit, drill 3 holes at the points
marked on the wall and push in the plugs.
6. Insert the upper screw and screw it in slightly.
7. Fit the upper part of the housing and insert the
other two screws.
8. Align the housing and tighten the three screws.
Achtung
C.2. - Wall instalion
Controller must be inaccessible
from the rear.
Caution
C.2.1.
C.2.2.
To Next Page
Loading...