Why is the wash tank filling time so long in my GRANULDISK Washer?
If the wash tank of your GRANULDISK Washer takes too long to fill, it could be due to a few reasons. First, check the water supply to the machine and the rinse pump. Also, try cleaning the rinse nozzles. After these steps, reset the alarm by pressing the STOP button. If the issue continues, it's best to contact a service engineer.
What to do if my GRANULDISK GRANULE SMART Washer has a long rinse time?
If your GRANULDISK Washer has a long rinse time, it means the correct water volume hasn't been reached in time. Try cleaning the rinse nozzles. Then, reset the alarm by pressing the STOP button. If the alarm appears again, contact a service engineer.
Why is the rinse tank filling time long in my GRANULDISK GRANULE SMART?
If the rinse tank of your GRANULDISK Washer is taking too long to fill, the rinse tank filling time has exceeded its limit. Check the water supply to the machine and the solenoid valve for the rinse tank filling. Then, reset the alarm by pressing the STOP button. Should the alarm appear again, contact a service engineer.
What to do if my GRANULDISK GRANULE SMART shows low water level and foam problems?
If you encounter a 'Low water level, problem with foam' error in your GRANULDISK Washer, there's likely foam forming in the machine. Avoid using detergent designed for washing up by hand. Also, change the wash water. If the foam issue persists, contact your detergent supplier. To clear the alarm, press the STOP button.
How to fix a 'Clean level sensor' error on my GRANULDISK GRANULE SMART Washer?
If your GRANULDISK Washer displays a 'Clean level sensor' error, it probably means the level sensor is dirty, or the water hasn't been exchanged after a long shutdown. Lower the water level and clean the level sensor in the wash tank, then refill the tank. If the sensor is already clean, reset the error and set the machine in heating mode for continued heating.
What to do if the 'Drain valve not closed' alarm appears on my GRANULDISK GRANULE SMART Washer?
If the 'Drain valve not closed' alarm appears on your GRANULDISK Washer, it means the drain valve opened during an active process. Simply close the drain valve and then reset the alarm by pressing the STOP button.
What to do if the door switch alarm goes off on my GRANULDISK GRANULE SMART?
If the door of your GRANULDISK Washer was accidentally opened during operation, triggering the 'Door switch' alarm, close the door and reset the alarm by pressing the STOP button.
How to unblock the basket drive device on my GRANULDISK Washer?
If you get a 'Basket drive device blocked' error on your GRANULDISK Washer, it means something is preventing the basket from rotating. Check for anything stuck between the basket and the basket wheel. After removing any obstructions, reset the alarm by pressing the STOP button.
Critical safety instructions, warnings, and precautions for machine operation.
Step-by-step instructions for initial setup and preparation of the machine.
Guidance on properly loading pots, pans, and utensils into the wash basket.
Instructions on selecting programs, starting cycles, and managing machine operation.
Information on common user error codes, meanings, causes, and solutions.
A detailed list of error codes, their causes, and recommended troubleshooting steps.
General| Capacity | 4 GN 1/1 or 8 GN 1/2 |
|---|---|
| Water Consumption | 2.5 liters per cycle |
| Power Supply | Varies depending on configuration. See official documentation. |
| Spin Speed | Not applicable |
| Programs | Normal |
To Next Page
