How do I resolve a 'Clean level sensor' error on my GRANULDISK Granule Flexi Washer?
If the GRANULDISK Washer displays a 'Clean level sensor' alarm, it indicates that the level sensor in the wash tank may be dirty, or water in the wash tank has not been totally drained at start up if the machine has been shut down for more than 4 hours. Empty the wash tank and clean the level sensor in the wash tank.
What to do if the door switch alarm goes off on my GRANULDISK Granule Flexi?
If the door switch alarm activates on your GRANULDISK Washer, it indicates that the door was opened during operation. Close the door and press the STOP button to reset the alarm.
What to do if the overheating protector for the wash tank tripped on my GRANULDISK Washer?
If the overheating protector trips for the wash tank on your GRANULDISK Washer, it means the wash tank heater has overheated. Clean the level sensor in the wash tank and then reset the overheat protection. If the error happens again within a few hours, contact a service engineer.
What should I do if a temperature sensor in my GRANULDISK Washer returns a false reading?
If one of the temperature sensors in your GRANULDISK Washer has returned a false reading, cut the power to the machine completely by switching the machine off at the wall socket. Wait 15 seconds. Switch the power back on. If the fault recurs, repeat the procedure once again. If the fault persists, contact service and ask them to replace one of the temperature sensors.
What to do if the drain valve not closed alarm appears on my GRANULDISK Granule Flexi?
If the drain valve opens during an active process in the GRANULDISK Washer, close the drain valve and reset the alarm.
Why does my GRANULDISK Granule Flexi Washer take so long to fill the rinse tank?
If the GRANULDISK Washer has a long rinse tank filling time, it could be because the level sensor in the rinse tank has not been activated within 5 minutes of the solenoid valve opening. Check the water supply to the machine, as well as the solenoid valve for rinse tank filling.
Why is the rinse time so short on my GRANULDISK Granule Flexi Washer?
If you're experiencing a short rinse time on your GRANULDISK Washer, it means the rinse water was pumped out too fast, leading to insufficient heating and rinsing. Contact a service engineer!
What should I do if the level detection function in the rinse tank of my GRANULDISK Washer is out of order?
If the level detection function in the rinse tank of your GRANULDISK Washer is out of order, it means there's a false level signal from one of the level sensors. Turn the machine OFF immediately! Continuing to operate it could damage other components. Contact a service engineer!
What does it mean if there is a system error and the control card is non operational on my GRANULDISK Washer?
If you encounter a system error indicating the control card is non-operational on your GRANULDISK Washer, it signifies that a control card component is broken. Contact a service engineer!
How do I clean the level sensor on my GRANULDISK Granule Flexi?
If you suspect the level sensor in your GRANULDISK Washer needs cleaning, it's likely dirty or the water hasn't been exchanged after a long shutdown. Lower the water level and clean the level sensor in the wash tank. Then, refill the tank. If the sensor is already clean, reset the error and set the machine in heating mode to continue heating.
General| Water Consumption | 15 liters per cycle |
|---|---|
| Material | Stainless Steel |
| Spin Speed | Not Applicable |
| Noise Level (Spinning) | Not Applicable |
| Energy Efficiency Class | Not Applicable |
To Next Page
