What should I do if the level detection function in the rinse tank of my GRANULDISK Washer is out of order?
If the level detection function in the rinse tank of your GRANULDISK Washer is out of order, it means there's a false level signal from one of the level sensors. Turn the machine OFF immediately! Continuing to operate it could damage other components. Contact a service engineer!
What to do if the operator's panel is broken on my GRANULDISK Granule Flexi Washer?
If the operator's panel is broken on your GRANULDISK Washer, it indicates a fault in the electronics of the panel. Contact a service engineer!
What happens if there is a wrong incoming voltage to the IO circuit board of my GRANULDISK Granule Flexi Washer?
If there is wrong incoming voltage to the IO circuit board of your GRANULDISK Washer, continuing to operate the machine can cause damage. Contact a service engineer!
General| Water Consumption | 15 liters per cycle |
|---|---|
| Material | Stainless Steel |
| Spin Speed | Not Applicable |
| Noise Level (Spinning) | Not Applicable |
| Energy Efficiency Class | Not Applicable |
To Next Page
