What to do if the motor protector for the right potwash pump tripped on my GRANULDISK Granule Flexi Washer?
If the motor protector for the right potwash pump has tripped on your GRANULDISK Washer, it indicates that the motor is overloaded. Contact a service engineer!
How do I resolve a 'Clean level sensor' error on my GRANULDISK Granule Flexi Washer?
If the GRANULDISK Washer displays a 'Clean level sensor' alarm, it indicates that the level sensor in the wash tank may be dirty, or water in the wash tank has not been totally drained at start up if the machine has been shut down for more than 4 hours. Empty the wash tank and clean the level sensor in the wash tank.
How do I clean the level sensor on my GRANULDISK Granule Flexi?
If you suspect the level sensor in your GRANULDISK Washer needs cleaning, it's likely dirty or the water hasn't been exchanged after a long shutdown. Lower the water level and clean the level sensor in the wash tank. Then, refill the tank. If the sensor is already clean, reset the error and set the machine in heating mode to continue heating.
What to do if the door switch alarm appears on my GRANULDISK Washer?
If the doors of the GRANULDISK Washer are opened during operation, close the door and reset the alarm.
What to do if the GRANULDISK Granule Flexi Washer door switch alarm goes off?
If the doors have accidentally been opened during operation, close the door and reset the alarm by pressing the STOP button.
Why does my GRANULDISK Granule Flexi Washer take so long to fill the rinse tank?
If the GRANULDISK Washer has a long rinse tank filling time, it could be because the level sensor in the rinse tank has not been activated within 5 minutes of the solenoid valve opening. Check the water supply to the machine, as well as the solenoid valve for rinse tank filling.
What should I do if a temperature sensor in my GRANULDISK Washer returns a false reading?
If one of the temperature sensors in your GRANULDISK Washer has returned a false reading, cut the power to the machine completely by switching the machine off at the wall socket. Wait 15 seconds. Switch the power back on. If the fault recurs, repeat the procedure once again. If the fault persists, contact service and ask them to replace one of the temperature sensors.
Why is the wash tank filling time so long on my GRANULDISK Washer?
If your GRANULDISK Washer is experiencing a long wash tank filling time, it means the wash tank filling has exceeded its time limit. Check the water supply to the machine and the rinse pump. Clean the rinse nozzles. Then, reset the alarm by pressing the STOP button. If the alarm continues, contact a service engineer.
What to do if the overheating protector for the rinse tank tripped on my GRANULDISK Granule Flexi Washer?
If the overheating protector trips for the rinse tank on your GRANULDISK Washer, it means that the rinse tank heater has overheated. You should clean the level sensor and reset the overheat protection. If the error code returns within a few hours, contact a service engineer.
What to do if the overheating protector for the wash tank tripped on my GRANULDISK Washer?
If the overheating protector trips for the wash tank on your GRANULDISK Washer, it means the wash tank heater has overheated. Clean the level sensor in the wash tank and then reset the overheat protection. If the error happens again within a few hours, contact a service engineer.
General| Water Consumption | 15 liters per cycle |
|---|---|
| Material | Stainless Steel |
| Spin Speed | Not Applicable |
| Noise Level (Spinning) | Not Applicable |
| Energy Efficiency Class | Not Applicable |
To Next Page
