4 HACCP Hygiene and Operation
Documentation
4.2 Reading the data through the
control panel
4.2 Reading the data through the control
panel
11 Press STOP button (2), release it and wait 3 seconds.
22 Press “Short program” (4), five times.
33 Use button “ECO program” (3) or button “Normal program (5) until you
see “read operating data” in the display. Confirm your choice by press-
ing Confirm button (1).
44 Operating data for the last program run is shown in the display;
200121 15:19 SG 65/85 OK
The information is defined as follows:
• Date; 200121 2020, January, 21st
• Time; 15.19 3.19 p.m
• Program type; E, S, N equivalent to Eco, Short and Normal program
• Washing with Granules; indicated by means of a “G”, otherwise this
box is left blank
• 65; indicates the average temperature in the wash tank during
washing.
• 85; indicates the minimum temperature in the rinse tank during
rinsing
• OK; indicates that you rinse with volume i.e. full volume (the programs
that are preset for this are Short and Normal). “NA” (not applicable)
will be shown if you rinse on time, i.e. not the entire volume (the pro-
grams that are preset for this are ECO and all COMBI/PLUS modes).
NOTE
If the wash program has been cancelled due to an oper-
ating error or technical error, the temperature indication is
not included and “error” plus an error code appears in its
place.
200121 15:19 SG Error 103
55 To view information on program run previously, scroll backwards and
forwards in the list using button “ECO program” (3) or button “Normal
program” (5).
66 To end scrolling and leave the list, press Confirm button (1).
77 Press the STOP button (2) to return to operating mode.
48 Rev. 2021-09
To Next Page
Loading...
