GRAPHTEC Craft ROBO CC200 - 2.4 Using the Carrier Sheet

Click the Output to Craft ROBO button
, confirm that the driver name
reads Graphtec Craft ROBO, and then
click the [OK] button to start the Craft
ROBO Controller.
Click the Output Settings button to
display the Output Settings window.
Click “Cutting Settings”, and then click
the [Cutline Settings] button to display
the [Cut Specifications] window. Make
sure that the Color checkbox for the
Cutline is checked. Click the [OK]
button, and then click the [OK] button in
the Output Settings window.
Select “Vinyl Sticker” in the Media Type
box.
Click the [Next] button to proceed to the
“Blade cap adjustment” step. Install the
blue cap displayed on the screen to the
blade holder tip.
Output Settings button
Click
Click
Make sure that this checkbox is checked
Output to Craft ROBO button
Click
Select “Vinyl Sticker”
33
Make preparations for cutting
1
Specify the cut line
2
Specify the cutting conditions
3
Load the vinyl sticker in your Craft ROBO and mount the blade, blade holder
12
Blade holder
Check that the blue blade adjustment cap has been attached to the blade holder, and
then mount the blade holder in the Craft ROBO. Mount the blade holder while making
sure that the protrusion on the holder faces the front and that it is aligned with the notch
in the clamp bracket. Firmly insert the blade holder in the clamp bracket and then turn
the lock lever to the right (CLOSE direction) to tighten the clamp bracket.
Click the “Next” button. The “Design Orientation” screen is displayed. Click the “Next”
button once again. The “Load Media” screen is displayed.
Close the top cover.
Click the [Next] button to proceed to the “Registration
Marks” step. Click the [Next] button again to proceed to
the “Start cutting” step.
Press the standby switch on the Craft ROBO, and confirm that the LED lamp on the
switch is lit (blue).
Align the left and right edges of the sheet with the vertical guidelines imprinted on the
front guide. While making sure that the sheet is straight, turn the feed knob until the top
edge of the sheet touches both pinch rollers.
Standby switch
Upper surface of blade holder
Holder protrusion
Pinch rollers
Guideline
Front
Lock lever
OPEN
CLOSE
Let’s try out the Craft ROBO
2