EasyManua.ls Logo

GRAPHTEC CE5000-60 - User Manual

GRAPHTEC CE5000-60
122 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
CE
5000 Series
USER’S MANUAL
MANUAL NO. CE5000-UM-153
CUTTING PLOTTER

Table of Contents

Other manuals for GRAPHTEC CE5000-60

Preview: Service Manual
Service Manual146 pages

Questions and Answers

  • D
    Dawn WilsonJul 26, 2025
    What to do if the GRAPHTEC CE5000-60 Plotter control panel LED is not lighting?
    • R
      robinsonjamesJul 26, 2025
      If the LED lamp on your GRAPHTEC Plotter's control panel isn't lighting up, or the LCD screen remains blank, here's what you can check: * Ensure the power cord is properly connected to the plotter's AC line inlet. * Verify the FPC504302 flexible cable is securely connected to both the main board and the control panel. If not, connect it securely. * Check if the FPC504302 flexible cable is broken and replace it if necessary. * Try changing the AC line to ensure the electrical output is correct. * See if the power supply unit has a 5V output; if not, replace the power supply unit. * Consider replacing the main board.
  • K
    Kendra BeckerAug 5, 2025
    Why does my GRAPHTEC CE5000-60 display OFFSCALE and not cut some areas?
    • M
      Melody KirbyAug 5, 2025
      The 'OFFSCALE' message appears because the received data extends beyond the defined cutting or plotting area. To resolve this, adjust the cutting or plotting area settings and verify the page-length setting.
  • J
    Julie WilliamsAug 15, 2025
    How to fix a GRAPHTEC CE5000-60 Plotter when the STATUS lamp doesn't light up?
    • D
      Donald HansenAug 16, 2025
      If the STATUS lamp on your GRAPHTEC Plotter's control panel isn't lit, it indicates a power supply issue. Ensure the power cord is properly connected both to the plotter's AC line inlet and the electrical outlet.

Summary

Introduction

Parts Names and Functions

Identifies and describes the plotter's components.

Setting Up the Cutter Plotter

Connecting to Your Computer

Instructions for connecting the plotter via serial or USB.

Loading the Medium

Procedures for loading roll or sheet media.

Basic Settings and Operations

Setting the Cutter-Pen Conditions

Optimizes settings for tool, offset, force, speed, and quality.

Setting the Initial Cutting Position (Origin Point)

Defines the starting point for cutting operations.

Function Settings and Operations

Reading the Auto Registration Marks

Describes the process of detecting registration marks for accurate cutting.

TEST Mode

Performs various tests for accuracy, data transfer, and demos.

Troubleshooting

The Cutting Plotter Does Not Operate Correctly

Addresses common operational errors, symptoms, and solutions.

The Cutting Results Are Unsatisfactory

Troubleshooting for poor cut quality and deformed output.

GRAPHTEC CE5000-60 Specifications

General IconGeneral
Mechanical Resolution0.005 mm
ConfigurationDesktop
Repeatability Precision±0.1 mm
Power SupplyAC 100-240V, 50/60 Hz
Power Consumption120 VA
ModelCE5000-60
CategoryPlotter
ManufacturerGraphtec
InterfaceUSB, RS-232C
Compatible Media Width50 - 620 mm
Programmable Resolution0.025 mm
Command SetsHP-GL, GP-GL
Blade TypeSupersteel
Media Thickness0.1 to 0.25 mm

Related product manuals