GRAPHTEC CE5000-60 - Setting the Registration-Mark Auto-Scan Mode

4 – 20
If the registration marks are at pre-determined positions on the medium, they can be scanned automati-
cally.
Press the (PAUSE) key to switch to PAUSE mode.
Press the (NEXT) or (PREV.) key until the following menu is displayed.
Press the (ENTER) key to display the Auto Reg. Mark submenu, and then press the (NEXT) or
(PREV.) key until the following menu is displayed.
Press the (ENTER) key to display the Auto-scan mode setting.
Press the or key to select “ON” or “OFF,” and then press the (ENTER) key to confirm. To cancel
the selection, press the (NEXT) or (PREV.) key.
Setting the Registration-Mark Auto-Scan Mode
Step
1
Step
2
Step
3
Step
4
Step
5
MARK MODE
MARK POSITION
MARK TYPE
MARK SIZE
MARK DIST. ADJ.
MARK OFFSET
MARK SENSOR ADJ1
MARK SENSOR ADJ2
MARK AUTO SCAN
MARK SENSOR ADJ
Registration-mark pattern 1
Medium feed direction
Registration-mark pattern 2
Move the pen tip within this area
Point 2Point 4
Point 1
(the desired
Origin Point)
Point 2
Point 4
Point 3
Point 1
(the desired Origin Point)
Point 3
Move the pen tip within this area
X
Y
When ON
was selected
100mm
100mm
Registration-mark pattern 1
Medium feed direction
Point 2Point 4
Registration-mark pattern 2
Move the pen tip within this area
Point 1
(the desired
Origin Point)
Point 2Point 4
Point 3
Point 1
(the desired Origin Point)
Point 3
Move the pen tip within this area
X
Y
When OFF
was selected
AUTO REG. MARK
MARK AUTO SCAN
AUTO SCAN ON