GRAPHTEC CE6000-60 - User Manual

CE6000-UM-251-13-9370
C E 6000 Series
SERVICE MANUAL
MANUAL NO. CE6000-UM-251
CUTTING PLOTTER

GRAPHTEC CE6000-60 Specifications

General

Model	CE6000-60
Max Cutting Width	603 mm
Maximum Cutting Area	603 mm x 50 m
Number of Tool Holders	1
Mechanical Resolution	0.005 mm
Repeatability	±0.1 mm
Power Consumption	120 VA
Max Cutting Speed	900 mm/s
Cutting Force	30 - 500 gf
Interface	USB 2.0, RS-232C
Software	Graphtec Studio
Configuration	Desktop
Drive Method	Digital servo drive
Mounting Method	Desktop
Offset Amount	0 to 1.0 mm
Programmable Resolution	0.025 mm
Media Type	Self-adhesive vinyl film, reflective
Command Sets	HP-GL, GP-GL
Power Supply	100 to 240 V AC, 50/60 Hz
Operating Environment	10 to 35 °C, 35 to 75 % R.H. (non-condensing)
Compatible OS	Windows
Weight	Approx. 21 kg
Pen Force	30 - 500 gf
Media Thickness	0.25 mm max

Summary

INTRODUCTION

Main Specifications

Details main specifications for CE6000 models, including dimensions, speed, and power.

DISASSEMBLY AND REASSEMBLY

Mechanical Parts

Details disassembly and reassembly procedures for various mechanical parts of the plotter.

Front Media Sensor

Pen Block

Detailed steps for detaching and reinstalling the pen block.

Main Board

Steps for detaching and reinstalling the main board.

Power Supply

Steps for detaching and reinstalling the power supply unit.

ELECTRICAL ADJUSTMENTS

DIP Switch Settings

Clearing the Non-Volatile RAM

Adjusting the Pen Force

Procedure for adjusting pen force, including measurement and setting.

Adjusting the Distance Accuracy

Steps for adjusting distance accuracy by drawing and measuring patterns.

Adjusting the Registration Mark Sensor Sensitivity

Procedure for adjusting the sensitivity of the registration mark sensor.

Upgrading the System Firmware

SERVICE MODES

Sensor and Key switch test Mode

Clear Setup Mode

Self Diagnostic Test

TROUBLESHOOTING

The Plotter is Turned On But Doesn’t Operate

Troubleshooting steps for when the plotter does not power on or display anything.

Media Loading Operations

Solutions for problems related to media feeding and detection.

Cutting Operations

Troubleshooting for issues like crooked cut lines or incomplete cuts.

ARMS Error Messages

Lists ARMS error codes, their causes, and solutions.

Troubleshooting of experience

PARTS LIST

Main Frame CE6000-40;60;Plus

Main Frame CE6000-120;120 AMO;120 Plus;120 AP

Pen Block CE6000-40;60;120;120 AMO;Plus

Pen Block CE6000-120 AP

BLOCK DIAGRAMS AND CIRCUIT DIAGRAMS