GRAPHTEC CE6000-60 - Drive Roller Shaft

CE6000-UM-251-9370 6-35
6 DISASSEMBLY AND REASSEMBLY
6.2.20 Drive Roller shaft
How to detach the drive roller
(1) Detach the right side cover (See section 6.1.1.).
(2) Detach the left side cover (See section 6.1.2.).
(3) Detach the rear guide (See section 6.1.6 for the CE6000-40/60, See section 6.1.7 for the CE6000-
120.).
(4) Detach the main board (See section 6.2.13.).
(5) Detach the Y motor (See section 6.2.12.).
(6) Loosen the tree M3L6 binding head screws holding the X-motor of the CE6000-40/60.
Loosen the two M3L6 binding head screws holding the X-motor of the CE6000-120.
M3L6 binding head screw
X drive belt
X drive pulley
CE6000-40/60
M3L6 binding head screw
X drive belt
X drive pulley
CE6000-120
(7) Push up the X-motor to remove the X drive belt from the X motor pulley and the X drive roller
pulley.
(8) Loosen the two M3L4WP set screws holding the X-drive pulley, and then detach the X-drive
pulley from the drive shaft.
M3L4WP set screw
X drive pulley
X drive roller shaft