GRAPHTEC CE6000-60 - Cutting Operations

CE6000-UM-251-9370 9-3
9 TROUBLESHOOTING
9.3 Cutting Operations
Symptom Verication item Solution
The cut line is crooked. (1) Does the blade turn well in the
blade holder?
No .....Replace the blade holder.
Yes .... Verify item (2).
(2) Do the X and Y drive motor belts
have the correct tension?
No .....Adjust the tension.
Yes .... Verify item (3).
(3) Is the Y belt attached correctly? No .....Attach it correctly.
Yes .... Verify item (4).
(4) Is the pen block attached
correctly?
No .....Attach it correctly.
Yes .... Verify item (5).
(5) Is the pen arm shaky? Yes .... Adjust the pen arm shaft slider
tension.
The blade skips and
does not completely
cut lines that should be
solid.
(1) The blade is extended too far. Adjust the blade length.
(2) The cutting SPEED is too high. Adjust the SPEED setting.
(3) Verify the pen force. Adjust the pen force.
(4) Verify the pen block height. Adjust the pen block height.