GRAPHTEC CE6000-60 - List of Items Requiring Readjustment

CE6000-UM-251-9370 7-2
7 ELECTRICAL ADJUSTMENTS
7.2 List of Items Requiring Readjustment
If you replaced one of the units listed in the table below or altered their sensor positions, be sure to
readjust the corresponding items.
Unit name
Item
Main board Pen block
Registration
mark sensor
-X, +X
paper
sensor
X,Y motor
X,Y Motor
drive belt
Drive roller
NOV-RAM clear M
Sufx setting M N
Pen force adjustment M M
Distance adjustment M M M
Registration mark
sensor adjustment
M (AP) M M (AP) M (AP)
-X, +X paper sensor
position adjustment
M M
Firmware update M
Belt tension
adjustment
M M M
Pen Exchange Y
Direction adjustment
MAP
Spacing Between
Pen 1 and Pen 2
adjustment
MAP
No mark: Unnecessary M: Must always be adjusted N: To be adjusted as necessary
(AP): The CE6000-120AP is not necessary to perform
MAP: Must always be adjusted only for the CE6000-120AP
Note: The main board must have the latest version of rmware unless otherwise specied.