GRAPHTEC CE5000-60 - Turning on the Power

2 – 3
2.2 Turning on the Power
Connect the cutting plotter to the AC electrical socket using the power cord provided, and turn on the
power.
Check to confirm that the Power switch is turned off (the “O” side is down).
Connect the cutting-plotter AC power inlet to a correctly rated electrical socket using the power cord pro-
vided.
Turn on the cutting plotter by pressing the “|” side of the Power switch. The STATUS lamp on the control
panel will light up.
Step
1
Step
2
Step
3
* The illustration below is of the CE5000-120 model.
* The illustration below is of the CE5000-120 model.
* The illustration below is of the CE5000-120 model.