3
3
BASIC SETTINGS AND OPERATIONS
3.1 Setting the Format of Data to be Received .......................3-2
3.2 Setting the Interface Conditions ...........................................3-4
3.3 Setting the Cutter-Pen Conditions .......................................3-5
3.4 Displaying the Effective Cutting Area .................................3-9
3.5 Moving the Pen............................................................................3-9
3.6 Setting the Initial Cutting Position (Origin Point) ...........3-10
3.7 Stop Function ............................................................................3-11
3.8 Moving the Pen Carriage in +100 mm Steps...................3-12
3.9 Test Cutting ................................................................................3-12
To Next Page
Loading...
