4 – 49
4.23 Setting the OFFSET FORCE (Initial Cutting Force)
This function specifies the cutting force to be applied during initial blade control for checking the cutter-
blade direction at the start of operation. This is used to control the rotation of the cutter-blade tip during ini-
tial blade control when thick media is cut, and is therefore not necessary to specify for media of regular
thickness. The initial setting is “4.” Increasing this setting increases the cutting force.
Press the (PAUSE) key to switch to PAUSE mode.
Press the (NEXT) or (PREV.) key until the following menu is displayed.
Press the (ENTER) key to display the offset-force setting menu.
Use the or key to select the value to be set, and then press the
(ENTER) key to confirm.
CE5000-60: “1” to “31”
CE5000-120: “1” to “38”
To cancel the selection, press the (NEXT) or (PREV.) key.
Press the (PAUSE) key to cancel PAUSE mode.
Step
1
Step
2
Step
3
Step
4
This setting is retained in the internal memory even when
the power is turned off.
FEED
MOVE TO R. MARK
AUTO PRE FEED
TANGENTIAL
AUTO REG. MARK
CLEAR BUFFER
AXIS ALIGNMENT
DISTANCE ADJUST
PAGE LENGTH
PLOT AREA
EXPAND
ROTATE
MIRROR
COPY
SORT
RS-232C
COMMAND
BLADE WEAR SETUP
PEN UP/DOWN
TEST MODE
PEN UP SPEED
OFFSET FORCE
OFFSET ANGLE
STEP PASS
INIT. DOWN FORCE
LENGTH UNIT
OFFSET FORCE
OFFSET FORCE 4
CHECKPOINT
To Next Page
Loading...
